![]() ![]() Please see ALIF: Accessing an Endpoint (TX or RX) Directly for instructions on how to connect, if you do not know how. Open the Web interface for the Receiver.P2P refers to “Point to Point” mode where the web server on the individual TX and RX units is used to set-up the device.Ĭhyronhego Intellicommander X-lyric keyboard If you find issues with specific USB devices please contact your supplier who will assist in determining whether there is a known patch code. This list will be updated periodically, but may not be up to date. The list is by no means exhaustive but these are devices that we know about. The table below lists the devices that Adder has come across that require an advanced USB code and their associated settings. It is the same code used by the Flow Control Mk2, which is code is 0x2000AAA or 33557162. In order to support card readers in firmware version 4.2 the following quirk is applied automatically when a card reader is reported. By applying this to the AdderLink Infinity the Unifying receiver will report itself to the host as an Adder VID and the Logitech set point is therefore disabled. When using Ubuntu 14.04 with the Logitech unifying receiver we have developed the following user code 0xAAE. We have come across an OS Ubuntu 14.04LS where the Logitech Set point Driver is built in and it is not possible to disable this. Unfortunately, as this uses a proprietary transmission protocol the AdderLink Infinity cannot support Logitech Set point and we recommend that this is uninstalled from the host computer. ![]() ![]() Logitech keyboards and mice that use the Logitech unifying receiver have the ability to use a special Logitech mode in order to provide extra functionality when the Logitech Set point Driver is installed on the host. The user code is 0x2000AAA in hex or 33557162 in decimal. ![]() This is buffer size flow control and is set by applying the following code 0x1000AAA or decimal 16779946 Flow control 2 V4.2 & aboveĪn improved version of USB Flow control was released in firmware version v4.2 and above. Flow control is required for a number of more complex USB peripherals including some touch screens and multi-function/combined devices. USB flow control has been introduced in Version V3.5 of the AdderLink Infinity firmware. AIM requires the codes to be entered as a decimal value and the AdderLink Infinities require them to be entered as a Hex value. There are two different input methods depending upon whether the AdderLink Infinity is being used point to point and the receivers’ web interface is being used or whether the AdderLink Infinity Receivers and AdderLink Infinity Transmitters are under A.I.M control. The patches are controlled in the USB Advanced Settings by adding a kernel or user code in the appropriate field. Rather than require the AdderLink Infinity system to be constantly updated with new device drivers the advanced USB settings allow a number of patches to be applied depending on the issue identified. Many of these solutions are only applicable to specific devices. As part of the ongoing support for AdderLink Infinity products, we are actively looking for solutions. The reasons for these problems have many root causes from issues with delays, specific configuration settings and much more. During the utilisation of AdderLink Infinity systems, a number of USB devices have been found to not function correctly. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |